H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 60
52
[AC2-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
5.
Verify the configuration:
After configuration, ping Host on Client, and you can see that Host is reachable. Use the display
vrrp command to view the configuration result.
# Display detailed information about VRRP group 1 on AC 1.
[AC1-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface Vlan-interface2
VRID : 1 Adver Timer : 1
Admin Status : Up State : Master
Config Pri : 110 Running Pri : 110
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : 10.1.1.10
Virtual MAC : 0000-5e00-0101
Master IP : 10.1.1.1
VRRP Track Information:
Track Object : 1 State : Positive Pri Reduced : 30
# Display detailed information about VRRP group 1 on AC 2.
[AC2-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface Vlan-interface2
VRID : 1 Adver Timer : 1
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : 10.1.1.10
Master IP : 10.1.1.1
The output shows that in VRRP group 1, AC 1 is the master and AC 2 is a backup. Packets from
Client to Host are forwarded through AC 1.
# Shut down the uplink interface VLAN-interface 3 on AC 1.
[AC1-Vlan-interface2] interface vlan-interface 3
[AC1-Vlan-interface3] shutdown
After shutting down the uplink interface on AC 1, you can still successfully ping Host on Client. Use
the display vrrp command to view information about VRRP group 1.
# After shutting down the uplink interface on AC 1, display detailed information about VRRP group
1 on AC 1.
[AC1-Vlan-interface3] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard