Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 30
22
Figure 10 Network diagram
Configuration procedure
1.
Perform basic configurations according to the topology requirements. (Details not shown.)
2.
Configure AC 1:
# Configure VLAN 2.
<AC1> system-view
[AC1] vlan 2
[AC1-vlan2] quit
[AC1] interface WLAN-ESS 1
[AC1-WLAN-ESS1] port link-type hybrid
[AC1-WLAN-ESS1] undo port hybrid vlan 1
[AC1-WLAN-ESS1] port hybrid vlan 2 untagged
[AC1-WLAN-ESS1] port hybrid pvid vlan 2
[AC1-WLAN-ESS1] quit
[AC1] interface vlan-interface 2
[AC1-Vlan-interface2] ip address 202.38.160.1 255.255.255.0
# Create VRRP group 1 on VLAN-interface 2 and set its virtual IP address to 202.38.160.111.
[AC1-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111
# Assign AC 1 higher priority than AC 2 in VRRP group 1, so that AC 1 can become the master.
[AC1-Vlan-interface2] vrrp vrid 1 priority 110
# Configure AC 1 to operate in preemptive mode so that it can become the master whenever it
works normally, and configure the preemption delay as five seconds to avoid frequent status
switchover.
[AC1-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5
3.
Configure AC 2:
# Configure VLAN 2.
<AC2> system-view
[AC2] vlan 2
[AC2-vlan2] quit
[AC2] interface WLAN-ESS 1
[AC2-WLAN-ESS1] port link-type hybrid
[AC2-WLAN-ESS1] undo port hybrid vlan 1