Elo TouchSystems ET1825L-8SWA-1 - Manual (Page 14)

Elo LCD Touchmonitor User Guide- 14
Cleaning Your LCD Touchmonitor
Prevent damage to your touchmonitor (and PC) by powering off the computer system and
disconnecting the touchmonitor from the AC out-let before you clean it. After you finish
cleaning, make sure the touch-monitor is completely dry before you reconnect the cables
and power it on. Do not apply liquid or aerosol spray cleaners directly on the screen or
cabinet. Do not use any type of abrasive pad, alkaline cleaner, scouring powder or
solvent (such as alcohol or benzine) to clean your touch-monitor. Avoid getting liquids
inside your touchmonitor. If liquid does get inside, have a qualified service technician
check it before you power it on again.
Screen
Remove dust and dirt by wiping the touch screen with a soft, clean, lint-free cloth.
Moisten a soft cloth with an ammonia-based glass cleaner and use it to remove
fingerprints and smudges.
Case
Clean the touchmonitor cabinet with a soft cloth slightly moistened with a mild detergent
solution. Rinse the cloth with clear water, wring it dry, and wipe the cabinet to remove any
detergent residue.
Safety
This manual contains information that is important for the proper setup and maintenance
of your touchmonitor. Before setting up and powering on your new touchmonitor, read
through this manual, especially Chapter 2 (Installation), and Chapter 3 (Operation).
To reduce the risk of electric shock, follow all safety notices and never open the
touchmonitor case.
Turn off the product before cleaning.
Your new touchmonitor is equipped with a 3-wire, grounding power cord. The power cord
plug will only fit into a three-prong safety ground outlet. Do not attempt to fit the plug into
an outlet that has not been configured for this purpose. Do not use a damaged power
cord. Use only the power cord that comes with your Elo TouchSystems Touchmonitor.
Use of an unauthorized power cord may invalidate your warranty.
The slots located on the sides and top of the touchmonitor case are for ventilation. Do not
block or insert anything inside the ventilation slots.
It is important that your touchmonitor remains dry. Do not pour liquid into or onto your
touchmonitor. If your touchmonitor becomes wet do not attempt to repair it yourself.
Chapter 5 – Care and Handling of your Touchmonitor (Continued)