Elo TouchSystems ET1825L-8SWA-1 - Manual (Page 8)

Elo LCD Touchmonitor User Guide- 8
Installing the Serial Touch Driver for MS-DOS and Windows
3.1
1. Insert the Elo CD-ROM in your computer’s CD-ROM drive.
2. From DOS, type d:\EloDW to change to the correct directory on the CD-
ROM (your CD-ROM drive may be mapped to a different drive letter).
3. Type install and press Enter to start the installation.
4. Align the touchscreen.
You must have already completed Steps 1 and 2 before proceeding. Refer
to Chapter 2 of the Elo DOS and Windows Driver Guide as necessary for
additional installation information.
1. Type INSTALL at the DOS prompt in the directory containing the driver
install files.
2. INSTALL asks you to select the software to install. Then choose
d:\EloDW from the displayed list.
3. INSTALL also asks you for the paths to use during installation, or you
may use its defaults. INSTALL creates directories as necessary, and
warns you if they exist.
4. If you are updating your software, you may wish to specify the paths
containing the earlier versions, and overwrite the obsolete files. All exe-
cutable programs are upward compatible. For a list of differences from
each previous version of the drivers, be sure to select "Differences from
Previous Versions" during the installation process.
5. INSTALL updates your AUTOEXEC.BAT file with the drivers you select.
INSTALL makes a copy of your original AUTOEXEC.BAT file, called
AUTOEXEC.OLD. If you already have Elo driver commands in your
AUTOEXEC.BAT file, they will be commented out.
6. When INSTALL is finished, it leaves a file called GO.BAT in the subdi-
rectory you specified. GO loads the touchscreen driver, runs the calibra-
tion program ELOCALIB, and gives you some final instructions.
7. If you are using Windows 3.1, you will also align the touchscreen within
Windows 3.1 with the Touchscreen Control Panel.
Chapter 2 – Installation and Setup (Continued)