Elo TouchSystems ET1825L-8SWA-1 - Manual (Page 7)

Elo LCD Touchmonitor User Guide- 7
Installing the Driver Software
Elo TouchSystems provides driver software that allows your touchmonitor to work with
your computer. Drivers are located on the enclosed CD-ROM for the following operating
systems:
Windows 2000
Windows 98
Windows 95
Windows NT 4.0
Windows 3.x
MS-DOS 2.x or later
Additional drivers and driver information for other operating systems (including OS/2,
Macintosh and Linux) are available on the Elo TouchSystems web site at
www.elotouch.com.
Your Elo touchmonitor is plug-and-play compliant. Information on the video capabilities of
your touchmonitor is sent to your video display adapter when Windows starts. If Windows
detects your touchmonitor, follow the instructions on the screen to install a generic plug-
and-play monitor.
Installing the Serial Touch Driver for Windows 2000, 95/98
and NT 4.0
Note: For Windows 2000 and NT 4.0 you must have administrator access
rights to install the driver.
1. Insert the Elo CD-ROM in your computer’s CD-ROM drive.
2. If the AutoStart feature for your CD-ROM drive is active, the system
automatically detects the CD and starts the setup program.
Follow the directions on the screen to complete the driver setup for your
version of Windows.
3. If the AutoStart feature is not active:
Click Start > Run.
Click the Browse button to locate the touch.exe program on the CD-ROM.
Click Open, then OK to run touch.exe.
Follow the directions on the screen to complete the driver setup for your
version of Windows.
Chapter 2 – Installation and Setup (Continued)