Elo TouchSystems ET1825L-8SWA-1 - Manual (Page 6)

Elo LCD Touchmonitor User Guide- 6
Touch Interface Connection
Note: Your interface cables may have been pre-connected to your monitor at the
factory.
1. Before connecting the cables to your touchmonitor and PC, be sure that the
computer and the touchmonitor are turned off.
2. Connect the ferrite end of the video cable to the video connector on your PC.
Connect the other end of the video cable to the touchmonitor. Secure the cable to
your touchmonitor and PC by turning the screws on the connector.
3. Connect the female end of the serial (RS-232) cable to the serial port on the back of
your PC. Connect the male end of the cable to the touchscreen connector on your
touchmonitor.
4. Power on your PC then your touchmonitor. After a brief pause the picture should
appear.
5. Install the driver software using the procedure described in the documentation
accompanying the driver disk.
Optimizing the LCD Display
To ensure the LCD display works well with your computer, configure the display mode of
your graphic card to make it less than or equal to 1280 x 1024 resolution, and make sure
the timing of the display mode is compatible with the LCD display. Refer to Appendix A
for more information about resolution. Compatible video modes for your touchmonitor are
listed in Appendix B.
VESA Mount on Your Touchmonitor
(Desktops Only)
Your desktop touchmonitor comes with a VESA standard mounting holes for additional
mounting options. Your touchmonitor conforms to the VESA Flat Panel Monitor Physical
Mounting Interface (FPMPMI™) Standard, which defines a physical mounting interface
for flat panel monitors, and corresponding standards for flat panel monitor mounting
devices, such as wall and table arms.
The following companies provide VESA mounting devices compatible with your
touchmonitor
Ergotron Innovative Office Products GCX
800-888-8458 800-524-2744 800-228-2555
651-681-7600 800-524-2744 707-773-1100
www.ergotron.com www.innov-office-prod.com www.gcx.com
Chapter 2 – Installation and Setup (Continued)