H3C Technologies H3C WA2600 Series WLAN Access Points - Manual (Page 23)

17
Checking the network connection for the fit AP
When the AP operates as a fit AP, all of its settings are configured on the AC.
You can use the display wlan ap all command to check the AP status on the
AC. When the AP status is R/M, the AP has been successfully connected to
the AC.
<AC> display wlan ap all
Total Number of APs configured : 1
Total Number of configured APs connected : 1
Total Number of auto APs connected : 0
AP Profiles
State : I = Idle, J = Join, JA = JoinAck, IL = ImageLoad
C = Config, R = Run, KU = KeyUpdate, KC = KeyCfm
--------------------------------------------------------
AP Name State Model Serial-ID
--------------------------------------------------------
ap1 R/M WA2620i-AGN 219801A0CNC118000435
--------------------------------------------------------
Checking the network connection for the fat AP
When the AP operates as a fat AP, use the ping command to ping the uplink
network. If the network can be pinged successfully, the AP is successfully
connected to the network.