H3C Technologies H3C WA2600 Series WLAN Access Points - Manual (Page 31)

25
Appendix LEDs and ports
LEDs
Table 3 describes the LEDs provided by the WA2620i-AGN.
Table 3 LED description
Mark Color Status Description
Green
Flashing at 1 Hz
The AP is booting.
NOTE:
When the AP operates as a
fit AP, it is always in this
state before it is registered to
an AC.
Breathing
A client is connected to the
2.4G port.
Blue
Flashing at 0.25
Hz
The AP has been booted,
and is in standby state (no
client is connected to the
AP).
NOTE:
When the AP operates as a
fit AP, this state indicates the
AP has been registered to
an AC.
Flashing at 4 Hz
The AP is updating its
system software image
(only available when the
AP operates as a fit AP).
Breathing
A client is connected to the
5G port.
Red Steady on
An initialization exception
has occurred to the AP.