Grass Valley FT Server - Manual (Page 50)

3. Confirm that the re-synchronization starts and the status of disks changes as shown below:
RDR Utility DISK ACCESS LED Resynchronizing
Status Op State: State
N/A Simplex Amber (Blinking) Source disk
N/A Syncing Amber (Blinking) Destination disk
Resync x percent
(x=0, 4, 8, ..., 96)
Simplex N/A RDR Virtual disk
RDR Utility DISK ACCESS LED Synchronization
completed
Status Op State: State
N/A Duplex Green (blinking) Source disk
N/A Duplex Green (blinking) Destination disk
None Duplex N/A RDR Virtual disk
Set as active RDR plex
A physical disk can be set as “Active RDR Plex” by a command.
Active RDR Plex is the disk on which the data reading process is performed when Load Balancing
of RDR Virtual Disk is off.
1. Start the RDR Utility and right-click a target disk in the left pane and click Set As Active RDR
Disk .
50 FT Server Instruction Manual 20131220
Configuring the FT Server