Grass Valley Jupiter v.1.0.0 - Manual (Page 42)

34 Jupiter AccuSwitch Soft Panels and Visual Status Display Instruction Manual
Section 3 — Multi-Level XY Soft Panel
7. Click the Execute Sequence button. An Execute Sequence dialog will then
appear notifying you that, “The sequence has been sent.” Click the OK
button.
8. Click the Close button, on the Sequence dialog, if you do not want to
execute any more sequences.
Selecting an Existing Sequence
Once a Sequence (or Salvo) has been created and saved, it can be used
again, as needed. The Existing Sequence drop-down list, in the Existing
Sequence section, will show all saved sequences.
To select an existing sequence:
1. Select the sequence from the Existing Sequences drop-down list. In the
example below, (
Figure 41 ) the “Beta” sequence has been selected.
Figure 41. Existing Sequences Drop-Down List
2. Click the View Sequence button. ( Figure 42 )
Figure 42. Existing Sequences Drop-Down List
The “Beta” sequence’s settings will then appear in the Sequence List.
Removing an Existing Sequence
If you feel you no longer need to keep a sequence, it can be removed from
the Existing Sequence drop-down list.
To remove an existing sequence:
1. Select the sequence from the Existing Sequences drop-down list, as
shown in
Figure 43 .
Figure 43. Existing Sequences Drop-Down List
2. Click the Remove Sequence button, as shown in Figure 44 .