Grass Valley K2 Media Client Service Manual Nov.18 2008 - Manual (Page 72)

72 K2 Media Client Service Manual July 28, 2008
Chapter 3 Service Procedures
15. When a “Backup archive creation has been successfully completed” message
appears, click OK .
16. Click Operations | Exit to exit the Acronis True Image program.
The machine restarts automatically.
17. Remove any CD that is still in the CD drive while the machine is shutting down.
Restoring from a system-specific recovery disk image on E:
The following procedure can be used on a K2 Media Client that needs its image
restored, if the image was made from that specific K2 Media Client. If the image is
the generic factory-default image, refer to
“Restoring from the generic recovery disk
image on E:” .
1. Make sure that media access is stopped and that the K2 Media Client on which you
are working is not being used.
2. If you have not already done so, connect keyboard, monitor, and mouse to the K2
Media Client.
3. Insert the Recovery CD and restart the machine. If there is a problem restarting,
hold the standby button down for five seconds to force a hard shutdown. Then press
the standby button again to startup.
The machine boots from the disc. The Acronis True Image program loads.
4. At the startup screen, select True Image (Full Version) .
The Acronis True Image program loads.
The Acronis True Image main window appears.
5. In the Acronis True Image main window, click Recovery .
The Restore Data Wizard opens.
6. On the Welcome page, click Next .
The Archive Selection page opens.
7. In the tree view expand the node for the E: partition and select the image file, then
click Next :
The Verify Archive Before the Restoring page opens.
8. Leave the selection at No, I don’t want to verify and then click Next .
The Partition or Disk to Restore page opens.
9. Select System (C:) and then click Next .
The Restored Partition Location page opens.
10. Select System (C:) and then click Next .
The Restored Partition Type page opens.
11. Leave the selection at Active and then click Next .
The Restored Partition Size page opens.
12. Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual C: partition. This should be the same as that reported in the