Rear facing customer display – Elo TouchSystems 1229L(WWW) User Manual
Page 31
2-26 Elo Entuitive Touchmonitor User Guide
Rear Facing Customer Display
Serial Customer Display
The serial customer displays do not need drivers. To get an image on the display:
1
Plug the DB-9 connector into serial port COM1 of computer.
2
Plug the RJ-45 cable into display.
3
In windows click on Start > Run
4
Enter cmd > OK
5
Type MODE COM1 96,N,8,1 > Enter
6
Type TYPE CON > COM1 > Enter
7
Type ELO > Enter
The display will show ELO.
USB Customer Display
Plug in the USB cable attached to the Customer Display unit. The New Hardware Wizard dialog box
will appear.
1
Choose Next and select “Search for the best driver for your device (Recommended)”
then choose Next.
2
When a list of search locations is displayed, place a checkmark on the drive containing the driver
package:
Touch Monitor Peripherals\Rear Facing Customer Displays\Drivers\xxx\LCLD9.sys, where xxx is
Win98 for a Windows 98 based system or 2000 for a Windows XP/2000 based system.
3
Insert the disk into your drive. (If the driver files have been copied to your hard drive or have
been distributed on CD, place a checkmark on “Specify a location” and browse to select the
directory containing the driver files.)
4
Choose Next. Once the Customer Display driver has been detected choose Next again.
5
Wait while driver files are copied to your computer.
6
Insert your Windows CD if prompted and choose Finish