3 operation, 1 control options, 2 card-edge leds – Grass Valley KMV-3901 Jul 30 2012 User Manual

Page 10: 1 status led, On 3.2.1)

Advertising
background image

6 | KMV-3901/3911

3 Operation

3.1 Control Options

The KMV-3901/3911 can be controlled in different ways:

On the Densité frame, the local control panel and its buttons can be used to navigate menus and adjust

parameter values (see section 3.3).

Miranda’s iControl system can be used to access the card’s operating parameters from a remote

computer, using a convenient graphical user interface (see section 3.4).

The loading and management of layouts is handled via a dedicated Java-based application, XEdit,

accessed through a dedicated Ethernet port (see the Kaleido-X User’s Manual).

A GPI interface allows remote layout selection.

The output resolution of the card can be controlled automatically through the EDID interface with the

display.

The Kaleido-RCP2 remote control panel allows you perform operations on the monitor wall, either by

itself or in association with an external keyboard and a mouse. Refer to the Kaleido-RCP2, and

Kaleido-X documentation (available on the DVD that shipped with your system).

3.2 Card-Edge LEDs

3.2.1 Status LED

The Status LED is located on the front card-edge of the KMV-3901/3911, immediately above the Select

button, and is visible through the front access door of the Densité frame. This multi-color LED indicates the

status of the KMV-3901/3911 by color, and by blinking/steady illumination:

LED

Meaning

Green

Normal

Blinking Orange Booting (or the card is selected for local control)
Red

No Ethernet / SD card error

Blinking red

Fan failure / no rear / duplicate IP address

The Status LED always shows the most severe detected error status that it is configured to display (see

section 3.4.5), and in the table above error severity increases from top to bottom, with green representing no

error/disabled, and blinking red the most severe error.

If the Status LED is blinking orange, it means that the card is selected for local control using the Densité

frame’s control panel, or that the card is booting up. See section 3.3 for details.

Advertising
This manual is related to the following products: