Grass Valley KMV-3901 Jul 30 2012 - Manual (Page 17)

GUIDE TO INSTALLATION AND OPERATION
KMV-3901/3911 | 13
The following table lists some (but not all) output formats supported on the MV OUT connections. Users can
customize their own timing rates through the XEdit software for resolutions ranging from 1280 × 1024 pixels
up to 1920 × 1200 pixels.
Resolution Format name Refresh rates (Hz)
1280 × 1024 SXGA 50.00, 59.94
1280 × 1024 BARCO 59.94
1360 × 768 NEC 50.00, 59.94
1480 × 1200 Christie 50.00, 59.94
1600 × 1200 UXGA 50.00, 59.94
1920 × 1080 Baycat 50.00, 59.94
1920 × 1200 WUXGA 50.00, 59.94
3.4.4 Network Settings Panel
Enter the IP address, mask and gateway
information to configure this KMV-3901/3911 within
your Ethernet network.
• These values apply to the rear-panel Ethernet
port of the KMV-3901/3911, and not to the
Ethernet ports of the Densité frame.
• The KMV-3901/3911 is shipped with default
values for the IP parameters. These will not
work for your network, and must be changed.
You may need to consult your IT department
to get the correct values.
The MAC Address is a hard-wired attribute of the
KMV-3901/3911 card, and is not configurable; the
information is presented here for information only.
Click Apply to set these values into the card, or
Cancel to leave the original values unchanged.
3.4.5 Alarm Configuration Panel
This panel allows the alarm reporting of the KMV-3901/3911 to be configured. The panel opens in a new
window when the button is clicked, and can be resized if needed.
The panel is organized in columns.
Figure 3.5 Network Settings panel