Grass Valley KMV-3901 Jul 30 2012 - Manual (Page 16)

12 | KMV-3901/3911
Each of the panels associated with the groups
accessed from the buttons in area 2, and shown in
area 3, is described individually below.
3.4.2 Layout Controls Panel
The two Layout lists are used to select the layouts
for the two Multi-viewer displays.
Some useful default layouts are stored on the KMV-
3901/3911 as shipped, for immediate use.
Additional layouts may be created in XEdit, and
exported to the KMV-3901/3911 via its rear-panel
Ethernet port. Refer to the Kaleido-X User’s Manual
for more information.
3.4.3 Output Settings Panel
Set the resolution of the multi-viewer output.
The resolution of the multi-viewer outputs should be
matched to the resolution of the displays they feed.
If the displays use EDID (Extended Display
Identification Data) to communicate their
characteristics to the KMV-3901/3911 via the HDMI
connector, the matching can be done automatically.
• The detected resolution will be displayed in
the Detected Resolution box.
• Select the check box to use the detected
resolution.
If the detected resolution is not used (either because
the check box is not selected or because the display
does not make the information available) the value
selected in the Output Resolution list will be used.
• The user must determine the appropriate
value based on the display in use.
• Each output is configured separately.
Figure 3.3 Layout Controls panel
Figure 3.4 Output Settings panel