Grass Valley Switcher Products - Manual (Page 88)

88 Switcher Products — Protocols Manual
Section 2 — Editor Protocol
All Stop (F2) Command
The ALL STOP command is issued to set all or a specific part of the
switcher to a known state. The command causes the following functions to
occur:
• Any ongoing KEY MIX is stopped,
• An ongoing AUTO TRAN (Transition) is stopped,
• An ongoing EFF DIS (Effects Dissolve) is stopped,
• An ongoing SEQ (Sequence) is stopped,
• The lever arms are set to a limit,
• The transition type is set to MIX,
• The transition mode is set to BKGD,
• All Keys are removed,
• Stop Effect Run, and
• The Source selections remain unchanged.
Kalypso Effects Addresses
Valid effects addresses used by Kalypso systems for the All Stop command
are defined in
Table 98 .
Table 97. All Stop Command
Function Byte Count Effects Address Command Code Message
Write 03 EX F2 FF
Table 98. Kalypso Effects Addresses - All Stop Command
Effects Address Assignment
00 PGM-PST
01 Mix/Effects 1
02 Mix/Effects 2
03 Mix/Effects 3
04 PGM-PST Secondary Partition
a
a New effects address assignment associated with Kalypso.
05 Mix/Effects 1 Secondary Partition a
06 Mix/Effects 2 Secondary Partition a
07 Mix/Effects 3 Secondary Partition
a
0B All Levels