Grass Valley LUMO Series - Manual (Page 22)

14
Status Card
Installation
Block Diagram
The following block diagram shows the functionality of the LUMO status card.
Installation
The Miranda LUMO-series Status card is installed in the center of the LUMO chassis, between the
two power supply slots.
To remove or install a LUMO status card, follow these steps:
1 Open the center front door, remove the door and push the door mounting brackets back
into the frame
2 Hook your finger over the plastic diffuser mounted at the front of the card, and pull out gen-
tly until the card is released from the rear connector; then slide the card out of the frame.
3 Slide the new card into the controller slot, and push gently on the card edge to engage the
rear connectors.
4 Pull the door mounting brackets back out of the frame, and re-install the door onto the
brackets.
5 Be sure to close the door before operating the LUMO system, to ensure proper ventilation.