Features and controls, Seat removal, Fuel cap – Polaris 2008 Ranger Crew User Manual

Page 36: Seat belts, Warning

Advertising
background image

33

FEATURES AND CONTROLS

Seat Removal

Pull up on the front of the seat and

slide it toward the front of the vehi-

cle.
Install the seat by sliding the tabs

into the rear of the seat base. Push

down firmly on the front of the seat

until the pins are fully seated into

the grommets.

Fuel Cap

The fuel tank filler cap is

located on the right-hand side of

the vehicle near the rear passen-

ger seat. When refueling, always

use either leaded or unleaded

gasoline with a minimum pump

octane number of 87 R+M/2

octane. Do not use E-85 fuel.

Seat Belts

The RANGER is equipped with lap-style seat belts for the operator and

passengers

.

To wear the seat belt properly, follow this procedure:
1. Place the belt across your lap as low on your hips as possible. Make

sure that the belt is not twisted.

2. Push the latch plate into the buckle until it clicks.
3. Release the strap, it will self-tighten.

NOTE:

The center belt must be tightened manually by pulling on the strap.

4. To release the seat belt, press the square red button in the buckle's

center.

WARNING

Falling from a moving vehicle could result in serious injury or death. Always

fasten your seat belt securely before operating or riding in the RANGER.
Passengers under five years of age require special restraints, which are not

available with this vehicle. No person under the age of five may ride in the

RANGER.

Seat Belt

Fuel Cap

Advertising