Features and controls, Trailer hitch bracket, Brake pedal – Polaris 2013 Ranger 800 Midsize User Manual
Page 22: Throttle pedal, Fuel cap, Seat removal
 
20
FEATURES AND CONTROLS
Trailer Hitch Bracket
This vehicle is equipped with a receiver hitch bracket for a trailer hitch. Trailer towing equip-
ment is not supplied with this vehicle.
To avoid injury and property damage, always heed the warnings and towing capacities out-
lined on pages 38-39.
Brake Pedal
Depress the brake pedal to slow or stop the vehicle. Apply the brakes while starting the 
engine.
Throttle Pedal
Push the pedal down to increase engine speed. 
Spring pressure returns the pedal to the rest 
position when released. Always check that the 
throttle pedal returns normally before starting 
the engine. Make sure there's adequate throttle 
pedal freeplay. See page 58
for throttle pedal
adjustment procedures.
Fuel Cap
The fuel tank filler cap is located on the right-
hand side of the vehicle near the passenger seat. 
When refueling, always use either leaded or 
unleaded gasoline with a minimum pump octane 
number of 87 R+M/2 octane. Do not use fuel with 
ethanol content greater than 10 percent, such as 
E-85 fuel.
Seat Removal
Pull up on the front of the seat and slide it toward 
the front of the vehicle. Install the seat by sliding 
the tabs into the rear of the seat base. Push down 
firmly on the front of the seat until the pins are 
fully seated into the grommets.
Throttle
Pedal
Brake
Pedal