Maintenance, Engine oil – Polaris 2013 Ranger 800 Midsize User Manual

Page 48

Advertising
background image

46

MAINTENANCE

Engine Oil

Always check and change the engine oil at the intervals outlined in the Periodic Maintenance
Chart beginning on page 43. Always change the oil filter whenever changing oil.

WARNING! Vehicle operation with insufficient, deteriorated, or contaminated engine oil will cause
accelerated wear and may result in engine seizure, accident, and injury. Always perform the
maintenance procedures as outlined in the Periodic Maintenance Chart.

Oil Recommendations

POLARIS recommends the use of POLARIS PS-4 PLUS Performance Synthetic 2W-50 4-
cycle oil or a similar oil. See page 76 for the part numbers of POLARIS products.

NOTICE: Mixing brands or using a non-recommended oil may cause serious engine damage. Always

use the recommended oil. Never substitute or mix oil brands.

Oil Check

The oil tank is located under the seat.

1. Position the vehicle on a level surface. Place the trans-

mission in PARK.

2. Remove the seat. See page 20.

3. Lift the lever lock to remove the dipstick. Wipe it dry

with a clean cloth.

4. Reinstall the dipstick completely, but do not lock it. The

dipstick must be screwed completely in to keep the angle
and depth of the stick consistent.

5. Remove the dipstick and check the oil level. Maintain

the oil level in the safe range. Do not overfill.

Tip: Due to the dipstick entry angle into the crankcase, the oil level

will read higher on the bottom side of the dipstick. Always read
the level on the upper surface of the dipstick.

6. After reinstalling the dipstick, be sure to seat the lever

lock.

7. Reinstall

the seat.

Safe

{

Safe

Range

Check Level

on Top Side

Dipstick

Add

Advertising