Polaris 2013 Ranger 800 Midsize - Manual (Page 46)

44
MAINTENANCE
Periodic Maintenance Chart
Perform all services at whichever maintenance interval is reached first.
► Perform these procedures more often for vehicles subjected to severe use.
E Emission-Related Service.
D Have an authorized POLARIS dealer perform these services.
Item Maintenance Interval
(whichever comes first)
Remarks
Hours Calendar Miles (Km)
Steering
Pre-Ride Make adjustments as need ed. See
Pre-Ride Checklist on page 30.
Front suspension
Rear suspension
Tires
Brake fluid level
Brake pedal travel
Brake system
Wheels/fasteners
Frame fasteners
Engine oil level
►
E
Air filter, pre-filter - Daily - Inspect; clean often; replace as needed
►
E
Air box sediment tube - Daily - Drain deposits when visible
Coolant (if applicable) - Daily - Check level daily, change coolant every
2 years
Headlamp/tail lamp - Daily - Check operation; apply dielectric
grease if replacing
►
E
Air filter, main element - Weekly - Inspect; replace as needed
►
D
Brake pad wear 10 H Monthly - Inspect periodically
Battery 20 H Monthly - Check terminals; clean; test
► Clutch Intake, pre-filter 25 H Monthly - Inspect; clean with compressed air;
replace if necessary
►
E
Engine breather filter (if equipped) 25 H Monthly - Inspect; replace if necessary
► Front Gearcase oil (if equipped) 25 H 1 M - Perform a break-in oil level check
► Middle Gearcase oil (if equipped) 25 H 1 M - Perform a break-in oil level check
► Rear gearcase oil (if equipped) 25 H 1 M - Perform a break-in oil level check
► Transmission oil 25 H 1 M - Perform a break-in oil level check
► Engine oil change (break-in) 25 H 1 M - Perform a break-in oil change at one
month
► General lubrication 50 H 3 M - Lubricate all fittings, pivots, cables, etc.
Shift Linkage 50 H 6 M - Inspect, lubricate, adjust
D Steering 50 H 6 M - Lubricate
► Front Suspension 50 H 6 M - Lubricate
► Rear Suspension 50 H 6 M - Lubricate
D
E
Throttle cable 50 H 6 M - Inspect; adjust; lubricate; replace if nec-
essary
E Throttle body air intake ducts/
flange
50 H 6 M - Inspect duct for proper sealing/air leaks
Drive belt 50 H 6 M - Inspect; adjust; replace as needed
Cooling system (if applicable) 50 H 6 M - Inspect coolant strength seasonally;
pressure test system yearly