HEIDENHAIN ND 720 v.3 - Manual (Page 66)

66
External
Operation
via
RS-232-C/V.24
Data
Interface
External Operation via RS-232-C/V.24 Data Interface
You can operate the display unit over the RS-232-C/V.24 data
interface using an external device.
The following commands are available on the ND 720 /
ND 760:
Format:
<ESC>TXXXX<CR> Key is pressed
<ESC>AXXXX<CR> Output of screen contents
<ESC>SXXXX<CR> Special function
Sequence of commands Meaning
<ESC>T0000<CR> ‘0‘ key
<ESC>T0001<CR> ‘1‘ key
<ESC>T0002<CR> ‘2‘ key
<ESC>T0003<CR> ‘3‘ key
<ESC>T0004<CR> ‘4‘ key
<ESC>T0005<CR> ‘5‘ key
<ESC>T0006<CR> ‘6‘ key
<ESC>T0007<CR> ‘7‘ key
<ESC>T0008<CR> ‘8‘ key
<ESC>T0009<CR> ‘9‘ key
<ESC>T0100<CR> ‘CL‘ key
<ESC>T0101<CR> ‘-‘ key
<ESC>T0102<CR> ‘.‘ key
<ESC>T0104<CR> ‘ENT‘ key
<ESC>T0107<CR> ‘1/2‘ key (datum)
<ESC>T0109<CR> ‘X‘ key
Sequence of commands Meaning
<ESC>T0110<CR> ‘Y‘ key
<ESC>T0111<CR> ‘Z‘ key (only ND 760)
<ESC>T0129<CR> ‘SPEC FCT‘ key
<ESC>T0142<CR> ‘R+/-‘ key
<ESC>T1000<CR> ‘CE+0‘ keys
<ESC>T1001<CR> ‘CE+1‘ keys
<ESC>T1002<CR> ‘CE+2‘ keys
<ESC>T1003<CR> ‘CE+3‘ keys
<ESC>T1004<CR> ‘CE+4‘ keys
<ESC>T1005<CR> ‘CE+5‘ keys
<ESC>T1006<CR> ‘CE+6‘ keys
<ESC>T1007<CR> ‘CE+7‘ keys
<ESC>T1008<CR> ‘CE+8‘ keys
<ESC>T1009<CR> ‘CE+9‘ keys
<ESC>A0000<CR> Output of model designation
<ESC>A0100<CR> Output of 14-segment display
<ESC>A0200<CR> Output of current value
<ESC>A0301<CR> Output of error text
<ESC>A0400<CR> Output of software number
<ESC>A0900<CR> Output of indicators
<ESC>S0000<CR> Counter RESET
<ESC>S0001<CR> Lock keyboard
<ESC>S0002<CR> Unlock keyboard
Bateil2.pm6 27.03.2002, 12:09 66