HEIDENHAIN ND 730 v.3 - Manual (Page 18)

18
ENT
X
Moving the Axes with Distance-To-Go
2 0
ENT
2 Z
Select the axis, e.g. Z, enter the nominal
coordinate, e.g. –20 mm, and confirm with ENT.
Move the Z axis until the display value is zero.
The tool is at position
2.
Select the axis, enter the nominal coordinate,
e.g. 20 mm (radius), confirm with ENT.
Move the X axis until the display value is zero.
The tool is at position
3.
Exit the distance-to-go mode.
The
∆ symbol goes out.
0
SPEC
FCT
and ENT
or
730_770t2.pm6 21.07.2004, 08:36 18