HEIDENHAIN ND 930 - Manual (Page 25)

25
Taper Calculator
3 0
0 1
2 0
DIA. RIGHT =
Enter value (for example, 10 mm) and confirm
with the arrow down key.
DIA. LEFT =
Enter value (for example, 20 mm) and confirm
with the arrow down key.
LENGTH =
Enter value (for example, 30 mm) and confirm
with the arrow down key.
ANGLE = 9.462
The result is displayed in the message field.
End the taper calculator.
• You can change entered values later by selecting them
with the arrow keys.
• Use the CL key to go back one level in the special functions.
SPEC
FCT