HEIDENHAIN PT 855 for Milling - Manual (Page 56)

I - 4 Programming POSITIP
54 Operating Instructions POSITIP 855
Y
X
Z
Transferring positions: Teach-In mode
Operating mode:
PROGRAMMING AND EDITING
Select
Teach-In
.
Go to
TEACH-IN / EDGE FINDER
. /
Example: Probe and transfer position on the X axis
Pre-position the Edge Finder near position you wish to probe.
Select the coordinate axis for which the value is to be transferred: X.
Retract the Edge Finder. Probe and transfer any further positions
in the same manner.
Move the Edge Finder against the workpiece edge until the LEDs
light up.
The coordinate of the probed position is now stored in the program.
Select radius compensation for later machining.
P r o b e i n X a x i s
Programming example for
TEACH-IN / EDGE FINDER
:
Probe island and transfer positions to a program
Probe the positions on a workpiece with a HEIDENHAIN KT Edge
Finder. The function
TEACH-IN / EDGE FINDER
transfers the
probed positions into a program.
The Edge Finder transfers the actual workpiece
positions into the program.