HEIDENHAIN MSE 1202 - Manual (Page 23)

23
Installing cable mounting hardware
A cable mounting hardware kit is provided with each module for routing cables. Each kit
contains two sets of mounting hardware.
X X Insert the M3 hex nut into the cable mounting slot 16 on the bottom of the module
X X Insert the M3 screw through the cable tie holder and fasten to the M3 hex nut using a
cross-head screwdriver
X X Insert the cable tie through the cable tie holder and fasten cables
Releasing a module
X X Verify power is removed from all power supply modules in the module chain
X X Press a flat-edge screwdriver into the lock tab receiver 8 opening at the top
left of the right hand module and press down on the lock tab 6 of the left hand
module to release the module
X X Gently apply upward pressure, depressing the DIN rail spring 11
X X While keeping upward pressure, rotate the top of the module away from the DIN rail
X X Gently release the upward pressure, releasing the module from the DIN rail
Releasing a module