HEIDENHAIN SW 54843x-02 - Manual (Page 225)

HEIDENHAIN MANUALplus 620 225
4.5 Recessing cy
cles
Recess turning, radial
Call the recessing cycles
Select recess turning
Select recess turning, radial
The cycle clears the rectangle described by the starting point and
contour end point.
Cycle parameters
X, Z
Starting point
X2, Z2 Contour end point
P Infeed depth: Maximum infeed depth
O Recessing feed rate (default: active feed rate)
B Offset width (default: 0)
U Unidirectional turning (default: 0)
 0: Bidirectional
 1: Unidirectional
G47 Safety clearance (see page 128)
G14 Tool change point (see page 128)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
MT M after T: M function that is executed after the tool call T