HEIDENHAIN SW 68894x-03 - Manual (Page 22)

22
4.4 Turning cycles ..... 158
Tool position ..... 159
Cut longitudinal ..... 161
Cut transverse ..... 163
Roughing, longitudinal—expanded ..... 165
Roughing, transverse—expanded ..... 167
Finishing cut, longitudinal ..... 169
Finishing cut, transverse ..... 170
Finishing cut, longitudinal—expanded ..... 171
Finishing cut, transverse—expanded ..... 173
Cut, longitudinal plunge ..... 175
Cut, transverse plunge ..... 177
Cut, longitudinal plunging—expanded ..... 179
Cut, transverse plunging—expanded ..... 181
Cut, longitudinal finishing plunge ..... 183
Cut, transverse finishing plunge ..... 185
Cut, longitudinal finishing plunge—expanded ..... 187
Cut, transverse finishing plunge—expanded ..... 189
Cut, ICP contour-parallel, longitudinal ..... 191
Cut, ICP contour-parallel, transverse ..... 194
Cut, ICP contour-parallel, longitudinal finishing ..... 196
Cut, ICP contour-parallel, transverse finishing ..... 198
ICP cutting, longitudinal ..... 200
ICP cut transverse ..... 202
ICP longitudinal finishing cut ..... 204
ICP transverse finishing cut ..... 206
Examples of turning cycles ..... 208