HEIDENHAIN iTNC 530 (340 420) - Manual (Page 509)

HEIDENHAIN iTNC 530 481
13.1 Gener
a
l User P
a
ra
met
e
rs
Graphic display mode MP7310
Projection in three planes according to ISO 6433, projection method 1: +1
Projection in three planes according to ISO 6433, projection method 2: +1
Do not rotate coordinate for graphic display: +0
Rotate coordinate system for graphic display by 90°: +2
Display new BLK FORM in Cycle 7 DATUM SHIFT referenced to the old datum: +0
Graphic simulation
without programmed
tool axis: Tool radius MP7315
0 to 99 999.9999 [mm]
Graphic simulation
without programmed
tool axis: Penetration
depth MP7316
0 to 99 999.9999 [mm]
Graphic simulation
without programmed
tool axis: M function
for start MP7317.0
0 to 88 (0: Function inactive)
Graphic simulation
without programmed
tool axis: M function
for end MP7317.1
0 to 88 (0: Function inactive)
Screen saver
Enter the time after
which the TNC should
start the screen saver
MP7392
0 to 99 [min] (0: Function inactive)
TNC displays, TNC editor