HEIDENHAIN iTNC 530 (340 422) - Manual (Page 528)

528 11 Programming: Q Parameters
1
1
.8 A
d
ditional F
unctions
4 Pocket
number Locked pocket: 0=no, 1=yes
5 Pocket
number PLC status
Pocket number of a tool in the tool-
pocket table, 52 1 Tool no. Pocket number
Immediately after TOOL CALL
programmed position, 70 1 - Position valid / invalid (1/0)
2 1 X axis
2 2 Y axis
2 3 Z axis
3 - Programmed feed rate (–1: no feed rate programmed)
Active tool compensation, 200 1 - Tool radius (including delta values)
2 - Tool length (including delta values)
Active transformations, 210 1 - Basic rotation in MANUAL OPERATION mode
2 - Programmed rotation with Cycle 10
3 - Active mirror axis
0: mirroring not active
+1: X axis mirrored
+2: Y axis mirrored
+4: Z axis mirrored
+64: U axis mirrored
+128: V axis mirrored
+256: W axis mirrored
Combinations = sum of individual axes
4 1 Active scaling factor in X axis
4 2 Active scaling factor in Y axis
4 3 Active scaling factor in Z axis
4 7 Active scaling factor in U axis
4 8 Active scaling factor in V axis
4 9 Active scaling factor in W axis
Group name, ID No. Number Index Meaning