HEIDENHAIN iTNC 530 (340 422) - Manual (Page 530)

530 11 Programming: Q Parameters
1
1
.8 A
d
ditional F
unctions
3 Z axis
4 A axis
5 B axis
6 C axis
7 U axis
8 V axis
9 W axis
Status of M128, 280 1 - 0: M128 inactive, –1: M128 active
2 - Feed rate that was programmed with M128
Triggering touch probe, 350 10 - Touch probe axis
11 - Effective ball radius
12 - Effective length
13 - Radius setting ring
14 1 Center misalignment in reference axis
2 Center misalignment in minor axis
15 - Direction of center misalignment compared with 0°
position
TT 130 Tool Touch Probe 20 1 Center point X axis (REF system)
2 Center point Y axis (REF system)
3 Center point Z axis (REF system)
21 - Probe contact radius
Measuring touch probe, 350 30 - Calibrated stylus length
31 - Stylus radius 1
32 - Stylus radius 2
33 - Setting ring diameter
34 1 Center misalignment in reference axis
2 Center misalignment in minor axis
35 1 Compensation factor for 1st axis
2 Compensation factor for 2nd axis
3 Compensation factor for 3rd axis
Group name, ID No. Number Index Meaning