HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot - Manual (Page 122)

122
Defining
Mach
ining
Posit
io
ns
Starting the pattern generator
The pattern generator for smarT.NC can be started two different ways:
„ Directly from the third soft-key row of the smarT.NC main menu, if you
want to directly define several point files in a row
„ From the form during the machining definition, if you want to enter
machining positions.
Starting the pattern generator from the main row of the editing
menu
8 Select the smarT.NC operating mode.
8 Select the third soft-key row.
8 Start the pattern generator: smarT.NC switches to the file
manager (see figure at right) and shows any existing point
files.
8 Select an existing point file (*.HP) and open it with the ENT
key, or
8 Create a new point file: Enter the file name (without the file
type), and confirm with the MM or INCH key. smarT.NC
creates a point file with the units of measurement you
selected, and then starts the pattern generator.