HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot User Manual
Page 46
46
D
e
fining Machining O
p
erations
Unit 240 Centering
Parameters on the overview form:
8
T:
Tool number or name (switchable via soft key)
8
S:
Spindle speed [rpm] or cutting speed [m/min or ipm]
8
F:
Centering feed rate [mm/min] or FU [mm/rev]
8
Select Depth/Diameter:
Select whether centering is based on the
depth or diameter.
8
Diameter:
Centering diameter. Input of T-ANGLE from TOOL.T
required.
8
Depth:
Centering depth.
8
Machining positions (see “Defining Machining Positions” on page
121.)
Additional parameters on the tool detail form:
8
DL:
Delta length for tool T.
8
M function:
Any miscellaneous function M.
8
Spindle:
Direction of spindle rotation. As a default, smarT.NC sets M3.
8
Tool preselect:
If needed, this is the number of the next tool for faster
tool change (machine-dependent).
Additional parameters on the drilling parameters detail form:
8
None