HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 50)

50 Fundamentals / overviews
1.
2
A
vailable
cy
cle
gr
oups
Overview of touch probe cycles
 The soft-key row shows the available groups of cycles
 If required, switch to machine-specific touch probe
cycles. These touch probe cycles can be integrated
by your machine tool builder.
Cycle group Soft key Page
Cycles for automatic measurement and compensation of workpiece misalignment Page 334
Cycles for automatic workpiece presetting Page 356
Cycles for automatic workpiece inspection Page 410
Calibration cycles, special cycles Page 460
Cycles for automatic kinematics measurement Page 476
Cycles for automatic tool measurement (enabled by the machine tool builder) Page 508