HEIDENHAIN TNC 620 (340 56x-02) ISO programming - Manual (Page 31)

HEIDENHAIN TNC 620 31
15.1 Selecting MOD Functions ..... 382
Selecting the MOD functions ..... 382
Changing the settings ..... 382
Exiting the MOD functions ..... 382
Overview of MOD functions ..... 383
15.2 Software Numbers ..... 384
Function ..... 384
15.3 Entering Code Numbers ..... 385
Application ..... 385
15.4 Setting the Data Interfaces ..... 386
Serial interfaces on the TNC 620 ..... 386
Application ..... 386
Setting the RS-232 interface ..... 386
Setting the baud rate (baudRate) ..... 386
Set the protocol (protocol) ..... 386
Set the data bits (dataBits) ..... 387
Parity check (parity) ..... 387
Setting the stop bits (stopBits) ..... 387
Setting the handshake (flowControl) ..... 387
Settings for data transfer with the TNCserver PC software ..... 388
Setting the operating mode of the external device (fileSystem) ..... 388
Software for data transfer ..... 389
15.5 Ethernet Interface ..... 391
Introduction ..... 391
Connection possibilities ..... 391
Connecting the control to the network ..... 391
15.6 Position Display Types ..... 397
Application ..... 397
15.7 Unit of Measurement ..... 398
Application ..... 398
15.8 Displaying Operating Times ..... 399
Application ..... 399
15 MOD Functions ..... 381