HEIDENHAIN TNC 620 (340 56x-02) ISO programming - Manual (Page 369)

HEIDENHAIN TNC 620 369
14.5 Pr
ogr
am Run
14.5 Program Run
Application
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or up to a program
stop.
In the Program Run, Single Block mode of operation you must start
each block separately by pressing the machine START button.
The following TNC functions are available in the program run modes
of operation:
„ Interrupt program run
„ Start program run from a certain block
„ Optional block skip
„ Editing the tool table TOOL.T
„ Check and change Q parameters
„ Superimpose handwheel positioning
„ Functions for graphic display (with advanced graphic features
software option)
„ Additional status display