HEIDENHAIN TNC 620 (340 56x-02) ISO programming - Manual (Page 355)

HEIDENHAIN TNC 620 355
13.1 Pr
ogr
amming and Ex
ecuting
Simple Mac
h
ining Oper
ations
Protecting and erasing programs in $MDI
The $MDI file is generally intended for short programs that are only
needed temporarily. Nevertheless, you can store a program, if
necessary, by proceeding as described below:
Select the Programming and Editing mode of
operation
Press the PGM MGT key (program management) to
call the file manager
Mark the $MDI file
To select the file copying function, press the COPY
soft key
Enter the name under which you want to save the
current contents of the $MDI file
Copy the file
Press the END soft key to close the file manager
For more information: see "Copying a single file", page 98.
TARGET FILE =
HOLE