Epson AVR-687 - Manual (Page 34)

Basic Operation Basic Operation
ENGLISH
31
ENGLISH
Use <INPUT SELECTOR> to select “TUNER” or press
[TUNER] .
Auto tuning
Manual tuning
Press [MODE] to set the auto tuning mode.
• The “AUTO” indicator lights.
Press TUNING .
• Automatic searching begins.
• If tuning does not stop at the desired station, use to the “Manual
tuning” operation.
• “AM” or “FM” can be selected directly by pressing [FM/AM].
Use <INPUT SELECTOR> to select “TUNER” or press
[TUNER] .
Press [MODE] to set the manual tuning mode.
Check that the display’s “AUTO” indicator turns off.
Press BAND to select “AM”, “FM” or “XM”.
When listening to the XM Satellite Radio ( page 32).
Press BAND to select “AM”, “FM” or “XM”.
When listening to the XM Satellite Radio ( page 32).
Press TUNING .
The frequency changes continuously when the button is held in.
1
2
3
4
1
2
3
4
• When the manual tuning mode is set, FM stereo broadcasts are
received in monaural and the “STEREO” indicator turns off.
• “AM” or “FM” can be selected directly by pressing [FM/AM].
Use the “Auto tuning” or “Manual tuning” operation
to tune in the station to be preset in the memory.
Press [MEMORY] .
Press CHANNEL to select the desired preset channel
(1 to 8).
Preset memory
Press SHIFT to select the desired memory block (A to
G).
Press [MEMORY] again.
• Store the station in the preset memory.
1
2
3
4
5
• To preset other channels, repeat steps 2 to 5.
A total of 56 broadcast stations can be preset — 8 stations (channels
1 to 8) in each of blocks A to G.
• The memory block can also be selected by pressing SHIFT.
Recalling preset stations
Press SHIFT to select the memory block.
Press CHANNEL to select the desired preset channel.
1
2
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
SHIFT
[FM/AM]
CHANNEL
[XM RADIO]
STATUS
D H F G
D H F G
[TUNER]
[MODE]
BAND
TUNING
[MEMORY]
SHIFT
STATUS
BAND
TUNING CHANNEL
<INPUT SELECTOR>