The pocket table tool_p.tch – HEIDENHAIN TNC 640 (34059x-04) ISO programming User Manual
Page 64
First Steps with the TNC 640
1.5
Setting up tools
1
64
TNC 640 | User's Manual for DIN/ISO Programming | 3/2014
The pocket table TOOL_P.TCH
The function of the pocket table depends on the
machine. Refer to your machine manual.
In the pocket table TOOL_P.TCH (permanently saved under
TNC:
\TABLE\) you specify which tools your tool magazine contains.
To enter data in the pocket table TOOL_P.TCH, proceed as follows:
Displaying the tool table: The TNC shows the tool
table
Display the pocket table: The TNC shows the
pocket table
Edit the pocket table: Set the
EDIT soft key to ON
With the upward or downward arrow keys you can
select the pocket number that you want to edit
With the rightward or leftward arrow keys you can
select the data that you want to edit
Exit the pocket table: press the
END key.
Further information on this topic
Operating modes of the TNC: See "Modes of Operation",
page 73
Working with the pocket table: See "Pocket table for tool