Yaskawa AI-010 User Manual
Warning, Caution
Yaskawa Electric America, Inc – www.drives.com
IG.AFD.50, Page 1 of 5
Date: 05/22/2007, Rev: 07-05
3-15PSI Pressure Transducer Option Card
AI-010
Part Number: AI-010.
Applicability: E7, F7, G7, P7, GPD506/P5, E7L (Electronic Bypass Control).
Introduction: This pressure transducer option card converts the air pressure (3-15PSI) applied to its on-board sensor to
electrical current, usable by both industrial and commercial air-conditioning systems. It can be used both as reference or
feedback signal generator. In case of feedback signal usage, the signal should be of course inverted by software or
external/system hardware. The card output range (4-20mA) is tunable by software or external/system hardware. The card
generally needs no calibration, as the accuracy is embedded inside its design.
WARNING
HAZARDOUS VOLTAGE CAN CAUSE SEVERE INJURY OR DEATH.
LOCK ALL INCOMING POWER SOURCES IN “OFF” POSITION.
• To prevent physical damage to the Drive or E7L Panel, Read these instructions thoroughly before installing.
• In GPD506/P5 Drives, an internal operator cable connects the front cover to the Drive. Take care when removing the front
cover.
• After installing the option, ensure all screws are tightened and the front cover is securely in place.
Option Kit AI-010 Contents
Item
No
Part Number
Description
Qty
1
5P70-0247
Brass Female to Male Adapter
2
2
None
3/8 inch Flat Washer
1
3
5P70-0246
Brass Hose Barb to Male Adapter
1
4
5P70-0245
1/8 inch PVC (vinyl) tubing
5 Ft
5
UTC000038
Pressure Sensor Card
1
Figure 1. AI-010 Option Kit
CAUTION
3
5
1
2
4
1
Document Outline
- Part Number: AI-010.
- Applicability: E7, F7, G7, P7, GPD506/P5, E7L (Electronic Bypass Control).
- Introduction: This pressure transducer option card converts the air pressure (3-15PSI) applied to its on-board sensor to electrical current, usable by both industrial and commercial air-conditioning systems. It can be used both as reference or feedback signal generator. In case of feedback signal usage, the signal should be of course inverted by software or external/system hardware. The card output range (4-20mA) is tunable by software or external/system hardware. The card generally needs no calibration, as the accuracy is embedded inside its design.