Epson X-PRF 1000 - Manual (Page 36)

Using speed dial faxing
S T O R E
M E M O R Y
START/COPY
Manual Redial
REDIAL
The Add Paper
Message Light
PriorityFax 1000 M anual
Repeat the above steps to create speed dial fax numbers 04
through 19.
After you have registered the speed dial numbers, you can send a
fax to any of those numbers in just five steps:
Insert the document face down in the feeder.
Lift up the handset and wait for a dial tone.
Press STORE/MEMORY.
Press the two numbers on the keypad corresponding to the speed
dial number you want to use.
When you hear the fax tone, press START and hang up.
You can redial the last number dialed by pressing DIAL TONE
RESET (the large button below the keypad) and then REDIAL.
The ADD PAPER message light on the top control panel lights up
when approximately four inches (10 cm) of paper is left. When you
see this light on, remove the old roll and follow the instructions in
Chapter 1 to insert a new roll.
2 - 1 2