Epson X-PRF 1000 - Manual (Page 44)

Troublesh ooting
Sending
(continued) Documents you sent are received blank.
Be sure you sent the document through the fax machine face
dow n. Resend the document, being careful to place the
document in the feeder face
dow n.
One-touch or speed dial faxing does not work.
You may have used a one-touch or speed dial number that is a
telephone number, not a fax number. Check to be sure the
number you are dialing is a fax number, and try again.
You may have pushed a one-touch or speed dial number that is
not registered properly. Check Chapters 2 and 3 for proper
registration procedures.
You may need to replace the memory batteries in the
PriorityFax. Follow the instructions on pages 2-3 through 2-4.
Receiving
M anual re ce ption doe sn’t w ork .
A document is in the feeder. Remove the document, and try
manual reception again.
Recoding paper is jammed.
Push down on the recording paper cover button to open up
the fax machine. Pull out the jammed recording paper. Use
scissors to make a clean edge on the end of the paper roll.
Reinsert the paper according to the instructions in Chapter 1.
Received copies an, blank.
The recording paper roll may be in upside down. Reinsert
the paper according to the instructions on pages 1-10 through
1-11.
Documents may have been sent to you incorrectly. Check with
the sending party.
Received documents are excessively curled.
This may happen when you are almost out of paper. You may
want to replace the recording paper roll.