KACO Powador 3200 - 6600 - Manual (Page 31)

EN
Configuration and Operation
Page 31 Operating Instructions for Powador 3200-6600_EN
Fault
!
Fault message The display shows the corresponding message.
The red "Fault" LED is illuminated.
The inverter is not ready for grid feed, i.e. no longer on
the grid.
Fault
!
Fault message The display shows a SYM bus parameter error.
8.1.2 Display
The display shows measured values and data and allows the configuration of the inverter. In normal operation, the
backlighting is switched off. As soon as you press one of the control buttons, the backlighting is activated. If no
button is pressed for a minute, it switches off again.
You can also activate or deactivate the backlighting permanently.
NOTE
Depending on the tolerances of the measuring elements, the measured and displayed values are not
always the actual values. However, the measuring elements ensure maximum solar yield. Due to
these tolerances, the daily yields shown on the display may deviate from the values on the grid
operator’s feed-in meter by up to 15 %.
After being switched on and after the initial start-up is complete, the inverter displays the unit name.
1
2
3
!
ok
Figure 23: Display (shows the unit name or menu item)
8.1.3 Control buttons
Operate the inverter with the two control buttons
1
2
3
!
ok
Figure 24: Control buttons
Key
1 Shift button Navigation to the next menu item
2 Setting key Make settings or selection
Key