Laney CD100 User Manual
Page 11
CD100 REAR PANEL
13. MAINS INLET SOCKET Connect to your power source. Make sure the voltage indicated on the rear panel is correct for your country!
14. MAINS FUSE This drawer contains the main safety fuse for the unit. USE ONLY THE CORRECT SIZE AND RATING SPECIFIED ON THE PANEL.
15. VOLTAGE SELECT SWITCH This is factory set to the correct voltage for the region the product is supplied to. If necessary it can be
reset by removing the mains lead and then loosening (but not removing) the screws securing the cover. The cover can then be pivoted away
from the switch which can be moved to select the alternate voltage. DO NOT reconnect the mains lead until the cover is replaced and
secured. Please ensure the correct fuse is fitted (as printed on the panel) for the voltage being used.
16. LOUDSPEAKER CONNECTIONS Two parallel jack sockets are provided for connection of loudspeakers. The minimum total
impedance is 4 ohms (2 x 8 ohm in parallel).
17. AUX IN RCA stereo input for the connection of an auxiliary source such as a CD/MP3 player etc. Signal level is adjusted using the Aux
Level control on the front panel.
18. RECORD OUT RCA stereo output for connection of recording devices. The Record Out feed is taken from before the master volume
control, and is therefore controlled by the individual channel level controls.