Laney CD100 - Manual (Page 13)

CD200 REAR PANEL
13. MAINS INLET SOCKET Connect to your power source. Make sure the voltage indicated on the rear panel is correct for your country!
14. MAINS FUSE This drawer contains the main safety fuse for the unit. USE ONLY THE CORRECT SIZE AND RATING SPECIFIED ON THE PANEL.
15. VOLTAGE SELECT SWITCH This is factory set to the correct voltage for the region the product is supplied to. If necessary it can be
reset by removing the mains lead and then loosening (but not removing) the screws securing the cover. The cover can then be pivoted away
from the switch which can be moved to select the alternate voltage. DO NOT reconnect the mains lead until the cover is replaced and
secured. Please ensure the correct fuse is fitted (as printed on the panel) for the voltage being used.
16. LOUDSPEAKER CONNECTIONS The CD200 is equipped with two independent power amplifiers, allowing two sets of speakers to
be driven independently. On each side, two parallel jack sockets are provided for connection of loudspeakers. The minimum total impedance is
4 ohms (2 x 8 ohm in parallel) per side.
17. AUX IN RCA stereo input for the connection of an auxiliary source such as a CD/MP3 player etc. Signal level is adjusted using the Aux
Level control on the front panel.
18. RECORD OUT RCA stereo output for connection of recording devices. The Record Out feed is taken from before the master volume
control, and is therefore controlled by the individual channel level controls.
MAXIMUM POWER CONSUMPTION
240 WATTS 50/60Hz
SUPPLY VOLTAGE & FUSE RATING:
CAUTION - RISK OF ELECTRIC SHOCK DO NOT OPEN
ATTENTION - RISQUE DE DÉCHARGE ÉLECTRIQUE, NE S'OUVRE PAS
SPEAKER OUTPUT A
(MINIMUM 4 OHM) SPEAKER OUTPUT B
(MINIMUM 4 OHM)
VOLTAGE SELECT
www.laney.co.uk
DESIGNED IN THE UK BY LANEY
N15039
SERIAL NUMBER
MODEL
CAUTION: TO REDUCE THE RISK OF FIRE REPLACE
FUSE WITH SAME TYPE AND RATING.
ATTENTION: POUR RÉDUIRE LE RISQUE DU FEU
REMPLACEZ AVEC LE MÊMES TYPE ET ESTIMATION.
WARNING: THIS APPARATUS MUST BE EARTHED.
CAUTION - HOT SURFACE!
120 V