Laney CD100 - Manual (Page 15)

N15039
CD300 REAR PANEL
16. MAINS INLET SOCKET Connect to your power source. Make sure the voltage indicated on the rear panel is correct for your country!
17. MAINS FUSE This drawer contains the main safety fuse for the unit. USE ONLY THE CORRECT SIZE AND RATING SPECIFIED ON THE PANEL.
18. VOLTAGE SELECT SWITCH This is factory set to the correct voltage for the region the product is supplied to. If necessary it can be
reset by removing the mains lead and then loosening (but not removing) the screws securing the cover. The cover can then be pivoted away
from the switch which can be moved to select the alternate voltage. DO NOT reconnect the mains lead until the cover is replaced and
secured. Please ensure the correct fuse is fitted (as printed on the panel) for the voltage being used.
19. POWER SWITCH
Turns the amplifier on and off. Ensure that the master level control is set to minimum before switching on and
off to prevent potential damage to your speakers. Make all speaker connections before switching on power to the amplifier.
20. AUX IN RCA stereo input for the connection of an auxiliary source such as a CD/MP3 player etc. Signal level is adjusted using Aux Level
on the front panel.
21. RECORD OUT RCA stereo output for connection of recording devices. The Record Out feed is taken from before the master volume
control, and is therefore controlled by the individual channel level controls.
22. LOUDSPEAKER CONNECTIONS Two parallel speakon compatible connectors are provided for the connection of loudspeakers.
For both sockets, signal is present between pins +1 and -1. The minimum total impedance is 4 ohms (2 x 8 ohm in parallel).
23. FAN OUTLET The CD300 is fan cooled. Do not obstruct the vents, and ensure adequate ventilation.
MAXIMUM POWER CONSUMPTION
450 WATTS 50/60Hz
SUPPLY VOLTAGE & FUSE RATING:
VOLTAGE SELECT