Edelbrock 3628 - Manual

©2008 Edelbrock Corporation
Brochure #63-3628
Catalog #3628
Rev. 4/08 - AJ/mc
ALUMINUM FUEL RAIL KIT
For 1986 - 1995 Ford 5.0L EFI engines
Catalog #3628
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with
common tools and procedures. However, you should be familiar with and comfortable working on your vehicle. If you do
not feel comfortable performing this installation, it is recommended to have the installation completed by a mechanic. If
you have any questions, please call our Technical Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard
Time, Monday through Friday or e-mail us at [email protected].
• DESCRIPTION: Aluminum Fuel Rail Kit #3628 is designed for 1986-1995 Ford Mustangs with the 5.0L V8 engine. This
fuel rail was designed to fit stock manifolds as well as Edelbrock Performer (3821), Performer RPM (7123), and Victor
Manifolds (2945). Spacers and/or grinding will be necessary for fuel rails to clear Edelbrock manifolds. It will be
necessary for the customer to supply their own fuel crossover and fuel pressure regulator, such as Edelbrock PN 1728.
It is designed to be used with stock or standard height injectors with a 2.50” o-ring to o-ring spacing such as our
Edelbrock MotoTron injectors. See our catalog under
“EFI Replacement Parts” for details.
• FUEL RAIL KIT: Install fuel rail kit and your injectors using the included 1/4”-20 bolts. Apply an o-ring assembly lube
to the injector o-rings before installing them into the manifold and fuel rails. Brake system assembly lube works well.
Make sure that the o-rings of the injectors create a complete seal with the fuel rail and the intake manifold to prevent
any air or fuel leaks.
Kit includes the following:
❑
2 - Machined fuel rail extrusions (fuel rail ends tapped for 3/8" pipe)
❑
4 - Fuel Rail Bracket
❑
4 - ¼”-20 x 1” Socket Cap Bolt
❑
4 - ¼”-20 Hex Nut
❑
8 - 10-32 x 1/2” Hex Cap Screws
❑
4 - ¼” .300” Spacers
❑
4 - ¼” Washers
❑
1 - 3/8” NPT Plug
• FINAL CHECKS: After finishing assembly, check the following:
❑ Check the fit of each injector. They should be able to rotate freely. The O-rings should be fully inside their
respective bores.
❑ Activate the fuel pump and fully check the system for any leaks prior to starting the engine.
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech-Line: 800-416-8628 • E-Mail: [email protected]
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and may
result in poor performance and engine or vehicle damage.