Bang & Olufsen BeoVision 10 User Guide - Manual (Page 46)

46
Two televisions in the same room
If you have placed your television
in a room where you already
have a Bang & Olufsen television,
and commands from your
remote control can be received
by both televisions, you must
change the Option setting of the
television. This prevents
simultaneous activation of both
televisions.
When you Option program the
television, disconnect the television
you do not want to program from
the mains. This ensures that only the
television, you want to program,
receives the Option programming.
One remote control for both televisions
For your television to function properly,
it is essential that the television is set to
the correct Option,
see page 44 for
information on Option programming.
You must set your television to Option 4,
and if you have a Beo6, you must also
select the correct zone*
1 .
Beo4 – Operate your television in
Option 4 …
Normally, you can activate a source, such
as TV, simply by pressing the relevant
source button on your remote control.
However, when you set your television
to Option 4, you must do the following,
if you have a Beo4:
> Press LIST and use the navigation button
up or down to bring up LINK in the Beo4
display.
> Press a source button, such as TV.
Beo4 operation.
Beo6 operation.
1 *NOTE! For information about choice of
zone, contact your Bang & Olufsen retailer.
BeoVision 10
Option 4
TV
LIST
LINK
TV
BeoVision 10
Zone ‘A’
Zone ‘B’
TV
Zone ‘A’
TV
BeoVision 10
Zone ‘B’