Assembling the handlebar and throttle, Transport position, handlebar, Assembly – English Leather 245R/RX User Manual
Page 20
20 –
English
ASSEMBLY
Assembling the handlebar and
throttle
(240R, 245R, 250R)
•
Remove the screw at the rear of the throttle handle.
•
Slide the throttle handle onto the right side of the
handlebar, (see diagram).
•
Align the screw hole in the throttle handle with the hole in
the handlebar.
•
Refit the screw in the hole in the rear of the throttle handle.
•
Screw the screw through the handle and handlebar.
Tighten it.
•
Unscrew the knob from the handlebar mounting.
•
Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
•
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that the
machine is in a comfortable working position when it
hangs from the harness.
•
Tighten the knob.
Assembling the handlebar and
throttle
(245RX, 252RX)
•
Unscrew the knob from the handlebar mounting.
•
Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
•
Fit the right handle to the handlebar using the screw,
washer, sleeve and nut as shown. Tighten.
•
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that the
machine is in a comfortable working position when it
hangs from the harness.
Tighten the knob.
Transport position, handlebar
(240R, 245R, 245RX, 250R, 252RX)
•
The handlebar can easily be turned to fit along the shaft
for easier transportation and storage.
•
Loosen the knob. Turn the handlebar clockwise so that the
throttle handle rests against the engine.
•
Now twist the handlebar around the shaft. Tighten the
knob.
•
Fit the transport guard to the cutting attachment.