Fitting other guards and cutting attachments, Adjusting the harness and clearing saw, Standard harness – English Leather 245R/RX User Manual

Page 23: Safety release, Spreading the load on your shoulders, Assembly

Advertising
background image

English

– 23

ASSEMBLY

Fitting the trimmer guard and
trimmer head Trimmy SII

Fit the correct trimmer guard (A) for use with the trimmer
head. Secure the trimmer guard using the 4 screws (L)
and the support plate (M) as shown.

Fit the drive disc (B) on the output shaft.

Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.

Insert the locking pin (C) in the hole to lock the shaft.

Screw on the trimmer head (H) in the opposite direction to
the direction of rotation.

Tighten the trimmer head to a torque of 35-50 Nm (3.5-5
kpm).

To dismantle, follow the instructions in the reverse order.

Fitting other guards and cutting
attachments

Fit the trimmer guard/combination guard (A) intended for use
with the trimmer head/plastic blades. Secure the trimmer
guard using the 4 screws (L) and the support plate (M) as
shown.

Fit the drive disc (B) on the output shaft.

Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.

Insert the locking pin (C) in the hole to lock the shaft.

Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.

To dismantle, follow the instructions in the reverse order.

Adjusting the harness and clearing saw

Standard harness

Safety release

At the front is an easily accessible, quick release. Use this if
the engine catches fire or in any other emergency situation
that requires you to free yourself from the machine and
harness.

Spreading the load on your shoulders

A well-adjusted harness and machine makes work much
easier. Adjust the harness for the best working position.
Tension the side straps so that the weight is evenly distributed
across both shoulders.

CAUTION! If the machine is to be used with a trimmer
head, the fast idle speed must be reduced by 400-500 rpm.
See instructions under the heading Carburettor.

B

A

L

M

C

H

!

WARNING! When using a clearing saw it
must always be hooked securely to the
harness. Otherwise you will be unable to
control the clearing saw safely and this can
result in injury to yourself or others. Never
use a harness with a defective quick release.

B

A

L

M

C

H

H

Advertising
This manual is related to the following products: